FAR-125

โพสต์เมื่อ : 19 ธ.ค 2562 เวลา 9:34 น.

Item/Model		Unit
Table Diameter		mm
Diameter of Table Central Hole		mm
Inner Diameter of Mandrel Sleeve		mm
Diameter of Center Through Hole		mm
Table Height (Horizontal)		mm
Table T-slot Width		mm
Guide Block Width		mm
Axis
Min. Increment		deg.
Indexing Precision		sec.
Repeatability		sec.
Clamping System (Pneumatic)		kg/cm2
Clamping Torque		kg-m
Servo Motor Model	FANUC	Taper/Straight shaft
Servo Motor Model	MITSUBISHI	Taper shaft
Speed Reduction Ratio		-
Max. Rotation Rate of Table (Calculate with Fanuc α Motor)		r.p.m
Allowable Inertia Load Capacity (Horizontal)		kg.cm.sec2
Allowable Workpiece Load	0º Horizontal	kg
Allowable Workpiece Load	0º~90º Tilt	kg
Allowable Load(with Rotary Table Clamping)	F	kgf
	FxL	kgf.m
	FxL	kgf.m
Strength of worm gears (Rotary axis)		kg.m
Net Weight (servo motor excluded)		kg

FAR-125/125B		FAR-170A (compact type)		FAR-170 (Standard type) / FAR-170B (Back side motor type)
Ø 125		Ø 170		Ø 170
Ø 35H7		Ø 67		Ø 67
-		Ø 40H7		Ø 40H7
Ø 25		Ø 40		Ø 40
215		245		270
12H7		12H7		12H7
14h7		18h7		18h7
Rotation	Tilt (－30º ～ +120º)	Rotation	Tilt ±100º	Rotation	Tilt ±100º
0.001	0.001	0.001	0.001	0.001	0.001
40	50 (30, if ECN-225 angle encoder is employed)	20	50 (30, if ECN-225 angle encoder is employed)	20	50 (Angle encoder can not be employed)
4	8	4	8	4	8
5	6	6	6	6	6
13	31	31	31	31	31
α2i / ß4is	α4i / ß8is	α2i / α4is / ß4is	α4i / ß8is	α4i / ß8is	α8i / α12is / ß12is
HF-75 / 105	HF-54 / 104	HF-75 / 105	HF-54 / 104 (Straight shaft is not available)	HF-54 / 104	HF-104
1：60	1：90	1：72	1：120	1：90	1：90
44.4	44.4	33.3	25	33.3	33.3
0.97		2.2		4.13
50		60		75
35		40		50
400		600		750
31		31		31
13		31		31
9		18		18
97		125		160