FHR Series

 โพสต์เมื่อ : 28 ม.ค 2563 เวลา 2:17 น.
FHR

FHR

Item/ModelUnit
Table Diametermm
Diameter of Table Central Holemm
Inner Diameter of Mandrel Sleevemm
Diameter of Center Through Holemm
Table Height (Horizontal)mm
Table T-slot Widthmm
Guide Block Widthmm
Axis 
Min. Incrementdeg.
Indexing Precisionsec.
Repeatabilitysec.
Clamping System (Pneumatic)
kg/cm2
Clamping Torquekg-m
Servo Motor ModelFANUCTaper/Straight shaft
MITSUBISHITaper shaft
Speed Reduction Ratio-
Max. Rotation Rate of Table (Calculate with Fanuc α Motor)r.p.m
Allowable Inertia Load Capacity (Horizontal)kg.cm.sec2
Allowable Workpiece Load0º Horizontalkg
0º~90º Tiltkg
Allowable Load(with Rotary Table Clamping)Fkgf
FxLkgf.m
FxLkgf.m
Strength of worm gears (Rotary axis)kg.m
Net Weight (servo motor excluded)kg

FHR-255C / 255CLFHR-320 (Standard type)FHR-320C (Cradle type)
Ø 255Ø 320Ø 320
Ø 110Ø 150Ø 150
Ø 80H7Ø 120H7Ø 120H7x30 deep
Ø 80Ø 120Ø 80
290355310
12H714H714H7
18h718h718h7
RotationTilt ±110ºRotationTilt ±100ºRotationTilt ±100º
0.0010.0010.0010.0010.0010.001
1550
(30, if ECN-225 angle encoder is employed)		1550
(30, if ECN-225 angle encoder is employed)		1550
(Angle encoder can not be employed)
484848
353535353535
7014011517570175
α4i / α8i / α12is / ß8is (Taper)α4i / α8i / α12is / ß12is (Taper)α8i / α12is / ß12is (Taper)α12i / ß22is (Straight)α8i / α12is / ß12is (Taper)α12i / ß22is (Straight)
HF-104HF-154HF-104HF-204HF-104HF-204
1：1201：1201：1201：1201：1201：120
2516.62516.62516.6
8.1325.625.6
100200200
75150100
150018001800
140175175
7011570
558055
296312470489